Feb 02, 2022
06:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 02, 2022
06:54 PM
I saw the link below.
Previously, MiniProg4 was not yet recommended for MBR3.
Currently, MiniProg4 seems to be able to work with the MBR3 configuration.
Is this correct?
Solved! Go to Solution.
Labels
- Labels:
-
CapSense
1 Solution
Feb 03, 2022
03:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 03, 2022
03:56 AM
Hi @NXTY_Inoue,
EZ-Click does not support Miniprog4.
However, you may use Miniprog4, as a USB-I2C bridge, to configure the MBR3 device. The .iic file, generated by EZ-Click, should be used to send the I2C commands through the bridge control panel.
Regards,
Nikhil
1 Reply
Feb 03, 2022
03:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 03, 2022
03:56 AM
Hi @NXTY_Inoue,
EZ-Click does not support Miniprog4.
However, you may use Miniprog4, as a USB-I2C bridge, to configure the MBR3 device. The .iic file, generated by EZ-Click, should be used to send the I2C commands through the bridge control panel.
Regards,
Nikhil