- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Figure 1 on page 6 of the IMC301A Datasheet shows the communication link to the ARM core only.
Does MCE designer have access to the MCE core directly?
Or is there a communication code loaded on the ARM core when using MCE wizard and MCE designer as a toolchain (no scripting) ? Where can I find this C code if this is the case?
Thanks for your help
Shiraz
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @shirazmacuff,
Thanks for posting in the Infineon Community.
Does MCE designer have access to the MCE core directly?
Yes, By default MCE designer will have direct access to MCE core through which you will be able to upload parameters and firmware.
Thanks,
Krupashankar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @shirazmacuff,
Thanks for posting in the Infineon Community.
Does MCE designer have access to the MCE core directly?
Yes, By default MCE designer will have direct access to MCE core through which you will be able to upload parameters and firmware.
Thanks,
Krupashankar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Krupashankar,
Is there a C code example that demonstrates accessing the MCE core without going trough the ARM core? As in the case with MCE designer.
Shiraz