- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
i need to flash the xmc4500 using the DAP Interface via Memtool but without open the Memtool GUI.
Any one has an Idee?
Thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1: Please refer to the attached file memtol_batch_mode.pdf.
2: create a bat file like below screenshot. Please note that: rename your hex file as fw.hex, and place it in C disk. If not, you should change the command.
3:Place the file into the same directory like the IMTMemtool.exe.
4: Run the command line just like below screenshot.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1: Please refer to the attached file memtol_batch_mode.pdf.
2: create a bat file like below screenshot. Please note that: rename your hex file as fw.hex, and place it in C disk. If not, you should change the command.
3:Place the file into the same directory like the IMTMemtool.exe.
4: Run the command line just like below screenshot.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the answer but i have another question please. Would this command works for every xmc? or do i need a config-file?
Best regards
Ziad
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, you don't need the config-file.