Sep 20, 2021
11:14 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2021
11:14 PM
Hello
I am using XMCFlasher and XMC1300 bootkit to program XMC1202-0032
I execute the following sequence :
change BMI to SWD0
erase
program with the hex file
reset the power supply
verify
XMCFlasher gives verify successfull, (file checksum is equal with memory checksum)
But if I save the memory content to my PC and compare with the hex file I programmed , they are different.
I run again the verify command on XMCFlasher software
I still get verify successfull
I am using XMCFlasher and XMC1300 bootkit to program XMC1202-0032
I execute the following sequence :
change BMI to SWD0
erase
program with the hex file
reset the power supply
verify
XMCFlasher gives verify successfull, (file checksum is equal with memory checksum)
But if I save the memory content to my PC and compare with the hex file I programmed , they are different.
I run again the verify command on XMCFlasher software
I still get verify successfull
Solved! Go to Solution.
- Tags:
- IFX
1 Solution
Oct 25, 2021
01:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2021
01:40 AM
Hi,
The default location goes to the address AAA since while reading the device, it reads all the flash location and also may be the hexfile is not overwriting the complete flash.
Regards
Alakananda
1 Reply
Oct 25, 2021
01:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2021
01:40 AM
Hi,
The default location goes to the address AAA since while reading the device, it reads all the flash location and also may be the hexfile is not overwriting the complete flash.
Regards
Alakananda