- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Are XMC4700 and XMC4800 binary compatible? That is a firmware written and compiled for XMC4700 could run on XMC4800, without recompile source code?
Thank you
Best Regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
This is possible. As most of the architecture is the same, this is possible but not vise versa. Again it is recommended to test your design with the new chip completely before as the recommended way is to recompile the code for 4800 and use that code.
Best Regards,
Vasanth R S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
This is possible. As most of the architecture is the same, this is possible but not vise versa. Again it is recommended to test your design with the new chip completely before as the recommended way is to recompile the code for 4800 and use that code.
Best Regards,
Vasanth R S