- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I want to use the analog comparator (ACMP) function of XMC1300_PG_PSSOP_28 to realize the overcurrent protection function. I hope that the current range can be controlled by programming; I would like to ask whether XMC1300_PG_PSSOP_28 can realize the programmable current range;
Solved! Go to Solution.
- Labels:
-
XMC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
By programming I am assuming you want to change the reference with the requirement. There is an option which could be helpful.
A resistor chain (in the order of 500kOhm) divides the reference voltage value from ACMP.REF input if bit ANACMP1.REF_DIV_EN is set. According to Figure the divided voltage is delivered to pin ACMP1.INP.
This is the programmability of the reference connected to ACMP.
Best Regards,
Vasanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
By programming I am assuming you want to change the reference with the requirement. There is an option which could be helpful.
A resistor chain (in the order of 500kOhm) divides the reference voltage value from ACMP.REF input if bit ANACMP1.REF_DIV_EN is set. According to Figure the divided voltage is delivered to pin ACMP1.INP.
This is the programmability of the reference connected to ACMP.
Best Regards,
Vasanth