- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a KIT_XMC1300_IFX9201 and must have someone save a Program on it. Does anyone know how to reset to factory settings? I am new here and do not have much knowledge. Just using it as a stepper Motor driver.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, @Enrico1 ,
Here is the link which can tell you how to set up your KIT_XMC1300_IFX9201 step by step:
https://github.com/Infineon/Stepper-Motor-Shield-IFX9201-XMC1300
Or you can refer to the User manual and the corresponding codes:
https://www.infineon.com/cms/en/product/evaluation-boards/kit_xmc1300_ifx9201/
Hope this can help you.
BR,
Owen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, @Enrico1 ,
Here is the link which can tell you how to set up your KIT_XMC1300_IFX9201 step by step:
https://github.com/Infineon/Stepper-Motor-Shield-IFX9201-XMC1300
Or you can refer to the User manual and the corresponding codes:
https://www.infineon.com/cms/en/product/evaluation-boards/kit_xmc1300_ifx9201/
Hope this can help you.
BR,
Owen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This thread will be closed due to long time no reply, you can create a new one if you have any other questions. Thanks for your understanding.
BR,
Owen