Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

Wi-Fi Combo Forum Discussions

Anonymous
Not applicable

I have modified snip.uart by changing all references to STDIO_UART to WICED_UART_2,

but no data is seen on the TX pin. Is there something else I need to configure to use this UART?

My platform is the ISM43362_MG3_L44.

0 Likes
1 Solution
Anonymous
Not applicable

No, nothing else is needed. I traced the problem to a pin numbering error on the

break-out board we built to plug into the ISM43362_MG3_L44 EVB expansion header.

View solution in original post

0 Likes
1 Reply
Anonymous
Not applicable

No, nothing else is needed. I traced the problem to a pin numbering error on the

break-out board we built to plug into the ISM43362_MG3_L44 EVB expansion header.

0 Likes