- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Has anyone run wiced SDK in STM32F4 discovery board using J-link (over SWD)? Is it possible to do so?
Best Regards,
Deepa.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You should wiring jlink JTAG signal TMS/TCK/TDI/TDO/TRST into STM32Fxxx JTAG signal by yourself
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The WICED SDK supports openocd with JTAG.
There are few discussions related to using ST-Link to work with WICED.
-Seyhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OpenOCD 0.7.0 not support SWD mode of jlink. but SWD of st-link work!
But the openocd embedded in SDK not enable ST-LINK option !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I don't want to use ST-link. Is there anyway I can use Wiced SDK with Discovery board using J-TAG interface only? (without using ST-Link)
Best regards,
Deepa.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You should wiring jlink JTAG signal TMS/TCK/TDI/TDO/TRST into STM32Fxxx JTAG signal by yourself
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thanks for the reply. I'll try this way.
Br,
Deepa.