Jun 23, 2021
01:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 23, 2021
01:03 AM
Hello.
I notice that if you connect 1KOhm resistor between PWM_5 (J6-2) and GND (SW3-4) in CYW954907AEVAL1F
or in CYW943907AEVAL1F and
try to program the demo board with WICED STUDIO...
after programming LED_1 start to blink and the processor doesn't start ...
Can someone help me ?
Solved! Go to Solution.
Labels
- Labels:
-
WICED Studio Wi-Fi Combo
1 Solution
Jun 23, 2021
05:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 23, 2021
05:09 AM
Please check the schematic of CYW954907AEVAL1f first.
You short the User_1 to ground.
2 Replies
Jun 23, 2021
05:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 23, 2021
05:09 AM
Please check the schematic of CYW954907AEVAL1f first.
You short the User_1 to ground.
Jun 23, 2021
05:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 23, 2021
05:21 AM
I use 1kOhm resistor ... at 3.3Volt current is 3.3mA .. is too high ?