- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a STM32F412+CYW43438 EVB to develop a ioT device.
I try to follow all debug configuration settings on forum but I get a problem here.
I set breakpoint at my application_start in Startup option but actually start at WICED/platform/ARM_CM4/crt0_GCC.c _start
Have someone to help this issue?
Solved! Go to Solution.
- Tags:
- Wiced debug
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Rakesh_BG,
Very appreciated your response, it work now.
Thanks a lot.
lx58
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @lx58 ,
You can refer to the document attached for the steps to debug on Wiced Studio .
Document gives the steps for 43907 . you can use by making small modifications .
Thanks,
Rakesh B G
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Rakesh_BG,
Very appreciated your response, it work now.
Thanks a lot.
lx58
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I got a problem now. I can't step into my application_start(). Even I modify Startup->Set breakpoint at: application_start. Have someone can help or point out what wrong is for me?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I try to modify Startup settings as below and debugging will start at _start in crt0_GCC.c
Press several F6 then tracing jump into application_start.