- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I compile the projector (wwd.canned_send-BCM943362WCD2-NoOS-NoNS-SPI download run)
try to start an ap with system no os .so add code to start ap ,but fail.
if ( wiced_wifi_start_ap( AP_SSID, AP_SEC, (uint8_t*) AP_PASS, sizeof( AP_PASS ) - 1, AP_CHANNEL ) != WICED_SUCCESS )
{
WPRINT_APP_INFO(("Failed to start : " AP_SSID " .. retrying\r\n"));
}
the place of fail is at wiced_send_ioctl function
get log :
Received a response for a different IOCTL - retry
- Labels:
-
SPI
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Did you resolve your issue by using OS and network stack?
Do you still have a question?
Seyhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Seyhan,
Don't have this issue by using os and network stack.
I have resolved this issue .
Thanks.
Best Regards
Chuang Chen
Shanghai R&D Center
Zhejiang Shenghui Lighting Co., Ltd
Tel: 021-60707500-8090
Mobile:18817395505
Email:chenc@sengled.com
发件人: seyhan
发送时间: 2015-01-08 10:07
收件人: chuang chen
主题: Re: - Can't start an AP with no OS and no network stack on platform of BCM943362WCD2 ?
Can't start an AP with no OS and no network stack on platform of BCM943362WCD2 ?
reply from seyhan in WICED Wi-Fi Forums - View the full discussion
Hi,
Did you resolve your issue by using OS and network stack?
Do you still have a question?
Seyhan
Reply to this message by replying to this email, or go to the message on Broadcom Community
Start a new discussion in WICED Wi-Fi Forums by email or at Broadcom Community
Following Can't start an AP with no OS and no network stack on platform of BCM943362WCD2 ? in these streams: Inbox