- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to program CYW943907AEVAL1F Eval Kit using Segger's J-Flash SW Tool and J-Link Pro device.
But I could see the following error (refer attached screenshot).
I could see that the device is detected and connected but finding issue while performing any other operations. I know that this is not the issue with WICED and its associated tools. Issue is only with Segger's J-Flash tool. But just wanted to check if any of you have already faced this issue and found the solution within this community.
Please help!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Update:
Segger confirmed that there is no support to these Part# to flash program with JFlash tools.
But as an alternative, we could program these tools using Segger JLink using OpenOCD and that solved my problem too.
Thanks,
Hari
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Update:
Segger confirmed that there is no support to these Part# to flash program with JFlash tools.
But as an alternative, we could program these tools using Segger JLink using OpenOCD and that solved my problem too.
Thanks,
Hari