May 21, 2018
12:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2018
12:19 AM
There is no error in the code, and the compile mode selects DEBUG to report the overflow error.
Solved! Go to Solution.
Labels
- Tags:
- debug overflow
1 Solution
May 21, 2018
07:30 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2018
07:30 PM
3 Replies
Attachments are accessible only for community members.
Anonymous
Not applicable
May 21, 2018
07:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2018
07:23 AM
Hi,
Please increase the value of SYS_MEM and DATA fields in the Fx3.ld file present in InstallPath\EZ-USB FX3 SDK\1.3\firmware\common\ folder, clean and build your project.
Please refer the picture I have attached, that will show the changes. (c1.jpg)
If you still get this error, please send us your firmware.
Regards,
- Madhu
May 21, 2018
07:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2018
07:04 PM
Hi, I have tried your method, modified the InstallPath\ ez-usb FX3 SDK\1.3\firmware\common\ fx.ld file, and tried to modify the fx.ld file of the error message path, but the project still prompts for overflow errors.
May 21, 2018
07:30 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 21, 2018
07:30 PM
Thank you for your prompt. It has been settled.