May 18, 2016
02:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 18, 2016
02:40 AM
hi:
i have done a fx3 PCB,when i connect to the pc,the control center can be distinguish it,but when i reset with the reset pin,the control center can not distinguish it,and when i download the firmware ,the control center can not distinguish it .i do not know what is the problem,i have tried to change another chip,but is also with the same problems.
1 Reply
Anonymous
Not applicable
May 18, 2016
10:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 18, 2016
10:06 PM
Does this happens when you do a RAM download also? Can you check which version of the driver your device is binding to? Did you get your schematics and layout verified by Cypress. Create a tech support case in Cypress.com to debug this issue further.