Nov 06, 2017
10:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 06, 2017
10:40 AM
Hi there,
I am using GPIF interface on FX3 chip in a serial mode, where only two data pins are involved (DQ14 and DQ15)
I would like to know is there a way to define state (high or low) of the output pin when I receive data on the input pin?
By default, when I am in the state to receive data, the output pin is held at 0. How can I make it to be 1 for the duration of the read cycle?
Many thanks,
Dima
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Nov 13, 2017
02:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 13, 2017
02:02 AM
Hi,
I am afraid, such a feature is not possible.
Regards,
- Madhu Sudhan
1 Reply
Anonymous
Not applicable
Nov 13, 2017
02:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 13, 2017
02:02 AM
Hi,
I am afraid, such a feature is not possible.
Regards,
- Madhu Sudhan