Anonymous
Not applicable
Aug 17, 2015
02:05 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 17, 2015
02:05 PM
I would like to have UART debugging enabled in my project. For that, I check UART box on the interface definition tab in the GPIF Designer (I modify the AN75779 project). Then, I save the project and build it. Everything is successful. Then, I close that project and open it again, but the UART box is unchecked. What could it be?
1 Reply
Anonymous
Not applicable
Aug 23, 2015
11:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 23, 2015
11:58 AM
Hi,
Please ignore the UART Check box in GPIF Designer. That has no effect on the project nor the state machine.
All UART related things are taken care only by the firmware witten in Eclipse
Regards,
- Madhu Sudhan