- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm trying to run FX3 for compliance testing. But It can't enter test mode. Are there any conditions to enter test mode?
Also, is there a way to tell if FX3 has entered test mode?
Thanks,
Tetsuo
Solved! Go to Solution.
- Labels:
-
USB Superspeed Peripherals
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Tetsuo san,
Please refer to this KBA Procedure for USB 3.1 Tx and Rx Compliance tests f... - Infineon Developer Community
The device will automatically enter compliance test mode after the expiry of the 360-ms counter as mentioned in the USB 3 Specification.
UART Debug Prints can be checked for USBBulkSrcSink firmware which shows the USB logs
Rashi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Tetsuo san,
Please refer to this KBA Procedure for USB 3.1 Tx and Rx Compliance tests f... - Infineon Developer Community
The device will automatically enter compliance test mode after the expiry of the 360-ms counter as mentioned in the USB 3 Specification.
UART Debug Prints can be checked for USBBulkSrcSink firmware which shows the USB logs
Rashi