Jan 30, 2019
10:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 30, 2019
10:50 PM
1 Solution
Jan 31, 2019
03:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 31, 2019
03:10 AM
Hi,
Yes, any standard JTAG Debugger can be used to Debug FX3 firmware.
Regards,
Anil Srinivas.
4 Replies
Jan 31, 2019
03:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 31, 2019
03:10 AM
Hi,
Yes, any standard JTAG Debugger can be used to Debug FX3 firmware.
Regards,
Anil Srinivas.
Jan 31, 2019
03:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 31, 2019
03:55 PM
You can debug the FX3 firwmare if your PC and USB are connected using the following products?
Jan 31, 2019
07:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 31, 2019
07:22 PM
The above picture of the product is wrong, so please check the picture below.
Feb 03, 2019
09:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 03, 2019
09:51 PM
Hi,
---Please share the details of FPU1 USB JTAG programmer.
Please refer "EzUsbSuite_UG.pdf. The chapter 3 of the document explain the JTAG debugging steps in detail. the document can be found in the FX3 SDK Installation directory.
Regards,
Anil Srinivas.