- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI:
Why are the following tips inconsistent, I configure sensor 2592 * 1944, bit8, 4lane, 518mbps, 104mpclk. How should I configure the Mipi interface
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Your configuration is correct. You can ignore the error displayed at Output pixel clock.
You can change the Multiplier of Unit clock value to 115. Doing so would give 92MHz Output PCLK which is more than minimum of 88.18MHz.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please share left column of the cx3 configuration tool also (MIPI CSI2 Inputs).
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Your configuration is correct. You can ignore the error displayed at Output pixel clock.
You can change the Multiplier of Unit clock value to 115. Doing so would give 92MHz Output PCLK which is more than minimum of 88.18MHz.
Regards,
Hemanth