Jan 05, 2023
03:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2023
03:49 AM
HI this is @clinton
I am generating the pwm wave in gpio 50 as a complex mode with cx3 rdk so i have an issue with this
i want to switch from complex to simple when duty cycle is zero i used overide api with correct parameters
the override function also worked . so problem is when duty cycle is zero I am changing the gpio to simple and set the value to zero but its not work in osciloscope its reflecting with 1 percent duty cycle and same in 100 perecent duty cycle also its showing around 99 percent can any one have any idea??
i am doing somewhere wrong i thinks guide me to reach the endpoint
Best Regards
clinton
1 Reply
Jan 05, 2023
09:12 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 05, 2023
09:12 PM
Hello Clinton,
Please share the code or the snippet where you are switching the complex GPIO to simple.
Thanks,
Sakshi Bakal