Anonymous
Not applicable
Jun 20, 2011
08:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 20, 2011
08:10 AM
I write different datum in CY7C68013's auto-in slave fifo, but the packet content are zeros.
The problem can't be in firmware because the firmware runs well on another board. So the problem must be in the hardware.
Do you know where may the problem be in the hardware probably? Thank you all.
1 Reply
Anonymous
Not applicable
Jun 20, 2011
08:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 20, 2011
08:14 AM
Scoping the slave FIFO data bus interface to what is being driven would be a good starting point.
Regards,
Anand