- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Description Resource Path Location Type
No Resolution found suitable for USB 2.0 Bandwidth. CyCx3USBHSConfigDscr[] is incomplete. Do not connect to USB 2.0 host or add a lower resolution to support USB 2.0 cx3config.cycx /cx3_Mipi_Mt9p031 Unknown Problem
i have refer to the link below.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you configure the description as USB 3.0 mode and ensure that CX3 enumerates as USB 3.0 device, you could ignore this notice. It just reminds you that the firmware you will get could not work in USB 2.0 mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you configure the description as USB 3.0 mode and ensure that CX3 enumerates as USB 3.0 device, you could ignore this notice. It just reminds you that the firmware you will get could not work in USB 2.0 mode.