Jun 05, 2022
05:28 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 05, 2022
05:28 PM
Hello.
I would like to know about the E-PAD connection for CY7C65213.
This device has an Exposed PAD.
It is recommended that the EPAD be connected to GND, but I do not want to solder it for the convenience of managing the state of the mounting.
Is it possible to use the EPAD without soldering?
Are there any (negative) effects of not soldering?
Regards,
Shimamura
Solved! Go to Solution.
1 Solution
Jun 05, 2022
09:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 05, 2022
09:32 PM
Hi,
As you might be aware EPAD is intended for heat sinking. So it should be soldered.
Regards,
Mallika
2 Replies
Jun 05, 2022
09:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 05, 2022
09:32 PM
Hi,
As you might be aware EPAD is intended for heat sinking. So it should be soldered.
Regards,
Mallika
Jun 05, 2022
11:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 05, 2022
11:43 PM
Hi Mallika,
Thank you for your reply.
OK, I will solder EPAD to GND.
Regards,
Shimamura