- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear i have a project to build a kind of usb mass storage product the design if finished and done by an engineer, i am a computer scientist so i don't know anything about.
I already order some proto pcb of my usb key, the design use this controller :
EZ-USB NX2LP-Flex ( from mouser : CY7C68023-56LTXC) and eight of S34ML04G1
So if i correctly understood the doc of the nand is programmed the controller act of mass storage device if not it act as "manufactur mode"
So what must be done to have a mass storage device working ?
Thanks in advance
Marc
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Marc,
You need to program the NAND using NandMfg Utility.
You can refer to Nand Manufacturing Utility section in the following document:
Please let us know for any doubts after going through this section.
Regards,
hman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Marc,
You need to program the NAND using NandMfg Utility.
You can refer to Nand Manufacturing Utility section in the following document:
Please let us know for any doubts after going through this section.
Regards,
hman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi i am able to program the nand with nandmfg.exe, the size and number of chip is correct. But the usb mass storage device is recognized by windows with a size of 8G instead of 32G ?
Also the usb is only recognized when the nandmfg is runing ?
Thanks in advance.
Marc