- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, brothers
I had a particular headache here:
After I have downloaded the firmware via USB Control Center to the usb chip, following the AN65209-get-start instructions,
my USB Control Center couldn't detect it
- pic1
But my computer can detect this interface,and I can guarantee that I'm using the matching drive
I am using the chip signal that is CY7C68013A that is documentation compliant
so why?
Thank you all for your answers
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
>> Could you please let me know if the board is FX2LP DVK or a custom board?
>> Kindly also let me know the driver details and the driver version.
Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maybe I already know why
Because of the firmware code is error,the chip may fall into a interrupt function while running the USB Control Center .(I am not using a board but a pure chip)
So the computer can detect the chip and the USB Control Center running code gets stuck like loading led(not on the chip)
Now I want to know how to solve it,Since opening the USB Control Center gets stuck, I need an other way to download the firmware.
thanks very much.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content