Anonymous
Not applicable
Sep 20, 2011
08:29 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2011
08:29 AM
In the datasheet, command write example doesn't say anything about SLWR line. But at the the timing diagrams (Figure 11-4. Command Asynchronous Write Timing Diagram) I see that SLWR line is strobed... Now my question is that should I do this while writing to Descriptor RAM??
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Sep 20, 2011
09:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2011
09:11 AM
Hi,
For always writing into SX2, SLWR should be asserted. In case of command write it should meet the timing as in Figure 11-4. Command Asynchronous Write Timing Diagram.
Regards,
Gayathri
1 Reply
Anonymous
Not applicable
Sep 20, 2011
09:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 20, 2011
09:11 AM
Hi,
For always writing into SX2, SLWR should be asserted. In case of command write it should meet the timing as in Figure 11-4. Command Asynchronous Write Timing Diagram.
Regards,
Gayathri