Mar 30, 2022
12:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 30, 2022
12:01 AM
I’m sorry, but please tell me a little more.
What are the specific steps to change the settings to use mode 3 on the CY7C65223D using the Configuration utility?
(Mode3 means Table13 and Table14 in Infineon-CY7C65223D-32LTXI-DataSheet-v01_00-EN.pdf)
Regards.
Solved! Go to Solution.
1 Solution
Attachments are accessible only for community members.
Mar 30, 2022
05:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 30, 2022
05:59 AM
Hi,
Please refer to the 2.3.2.3.1 UART Mode section of the USB-Serial Configuration Utility User Guide attached to this response to change to Mode 3 (8-pin UART).
Regards
4 Replies
Attachments are accessible only for community members.
Mar 30, 2022
05:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 30, 2022
05:59 AM
Apr 01, 2022
12:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2022
12:07 AM
Thank you very much for your answer.
If I change the setting to Mode3(8-pin UART) using Configuration Utility, will that setting be written to Flash memory?
Regards
Apr 04, 2022
08:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 04, 2022
08:54 PM
Hello,
I have posted an additional question to the Community, so please check it.
Regards
I have posted an additional question to the Community, so please check it.
Regards
Apr 05, 2022
05:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 05, 2022
05:48 AM
Hi,
Yes, the configuration information is stored in Flash memory.
Regards