Jan 17, 2022
11:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 17, 2022
11:54 AM
Is there any USB microcontroller Full Speed at Cypress family where I can use the D+ and D- to program the firmware into the chip?
I need just 4 digital GPIO for my project, but its important to program the chip using USB conector (D+ and D-) as I did with Low Speed Encore II microcontroller.
Best Regards,
@anne_4609456
Solved! Go to Solution.
Labels
1 Solution
Jan 17, 2022
11:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 17, 2022
11:15 PM
Hi,
You may refer to the Encore III controller.
However, there is no provision of programming using the D+/D- lines.
Regards,
Mallika
1 Reply
Jan 17, 2022
11:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 17, 2022
11:15 PM
Hi,
You may refer to the Encore III controller.
However, there is no provision of programming using the D+/D- lines.
Regards,
Mallika