- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I've writen an data acquisition software based on CyAPI wich communicate with an FX2 chip. It use asynchronous bulk communication ( packet size: 512 byte, 16 MByte/sec ). The implementation follow the recommendations of Cypress which can be found in the example programs: overlaped I/O, BeginDataXfer, WaitForXfer, FinishDataXfer.
It works correctly on my previous computer (desktop PC, Windows 7, USB 2.0, i5) but on my new one (Laptop, Windows 10, USB 3.0, 8th gen. i5 ) the transfer always breaks after few seconds.
Could you give me any advice?
Viktor
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Viktor,
Please check the driver version that you are using.
For windows 10 RS3, the driver version of cyusb3 is 1.2.3.20
Please check you windows 10 build version.
Refer to the below link where I have posted the driver:
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Viktor,
Please check the driver version that you are using.
For windows 10 RS3, the driver version of cyusb3 is 1.2.3.20
Please check you windows 10 build version.
Refer to the below link where I have posted the driver:
Regards,
Hemanth