- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
In CY7C65215, is it possible to control ON/OFF of RTS and DTR by control transfer request (SET_CONTROL_LINE_STATE) of CDC from host?
Regards.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
No, CY7C65223 firmware does support SET_CONTROL_LINE_STATE. I did a simple test to demonstrate this-
>> Configured CY7C65223 from the USB serial configuration utility to UART CDC mode, 4-pin. Using a terminal application, I enabled flow control and toggled the RTS button (as shown in the attached screenshot). The toggling was observed on RTS line and is captures using a saleae logic analyzer.
Apologies for misunderstanding your question in the first place.
Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Kindly note that CY7C65215 is a fixed firmware part. Such changes in the firmware cannot be made.
Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Thank you for your answer.
Does this mean that the CY7C65223 firmware does not support the SET_CONTROL_LINE_STATE request in the CDC class?
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
To add to my previous question, I would like to connect RTS and DTR to the microcontroller and switch them under control from the host side. Is it possible?
For example, RTS and DTR are controlled from the host side, and mode switching is performed on the microcontroller side.
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
No, CY7C65223 firmware does support SET_CONTROL_LINE_STATE. I did a simple test to demonstrate this-
>> Configured CY7C65223 from the USB serial configuration utility to UART CDC mode, 4-pin. Using a terminal application, I enabled flow control and toggled the RTS button (as shown in the attached screenshot). The toggling was observed on RTS line and is captures using a saleae logic analyzer.
Apologies for misunderstanding your question in the first place.
Regards,
Mallika