Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

USB low-full-high speed peripherals

UserP1994
Level 3
10 replies posted 10 questions asked 10 sign-ins
Level 3

hello,

I want to attach an ox03a10 camera to my pcb, can someone tell me how I could configure it to be able to take the picture ? thank you

0 Likes
1 Solution
PranavaYN
Moderator
Moderator 50 likes received First comment on KBA First question asked
Moderator

Hi,

 

Can you please specify your exact requirement?

Are you looking for a USB peripheral controller to interface the camera with the PC?

Following KBA and AppNote can be of some interest to you,

https://www.cypress.com/file/123506/download#:~:text=FX3%20uses%20its%20General%20Programmable,USB%2....

https://community.cypress.com/t5/Knowledge-Base-Articles/Interfacing-FX2LP-with-Image-Sensor-KBA9573....

If you let us know the exact requirement from your side, we would be able to help you better.

Best regards,
Pranava

View solution in original post

0 Likes
3 Replies
PranavaYN
Moderator
Moderator 50 likes received First comment on KBA First question asked
Moderator

Hi,

 

Can you please specify your exact requirement?

Are you looking for a USB peripheral controller to interface the camera with the PC?

Following KBA and AppNote can be of some interest to you,

https://www.cypress.com/file/123506/download#:~:text=FX3%20uses%20its%20General%20Programmable,USB%2....

https://community.cypress.com/t5/Knowledge-Base-Articles/Interfacing-FX2LP-with-Image-Sensor-KBA9573....

If you let us know the exact requirement from your side, we would be able to help you better.

Best regards,
Pranava
0 Likes
UserP1994
Level 3
10 replies posted 10 questions asked 10 sign-ins
Level 3

Hello,

 

I have this Error -> 
No Resolution found suitable for USB 2.0 Bandwidth. CyCx3USBHSConfigDscr[] is incomplete. Do not connect to USB 2.0 host or add a lower resolution to support USB 2.0 cx3config.cycx /Cx3UvcAS0260 Unknown Problem

do you know why and what can I do? thank you

 

0 Likes
Rashi_Vatsa
Moderator
Moderator 500 solutions authored 1000 replies posted 750 replies posted
Moderator

Hello,

It seems that you are using CX3 in your application . Please confirm.

Please let me know when is this error seen. Is the error seen when steps similar to this  Steps to Setup up MIPI CSI Camera Solution with CX... - Cypress Developer Community   KBA are followed? If yes, you can ignore the error if the device will work only in USB 3.0. If the device is expected to work in USB 2.0 as well then a video resolution (supported by USB2.0) needs to be added in the CX3 configuration tool.

Regards,
Rashi
0 Likes