- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Everyone !
I have attached Flash Nands with my Controller and am using it as a usb(MSC) drive.
How to read/write file or data to a certain address to the nand and verify it by a fixed command over uart before enumerating as msd.
Basically the purpose here is to verify health of the attached nands
Any help would be highly appreciated.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you please explain your application better? We will be able to assist you better then.
Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Thanks for taking interest and replying.
Well my requirement is to indicate the health of my NAND FLASHES ( 4 in my case , each of 2GB) through uart protocol to external serial terminal attached along either through uart0 or 1.
I don't want to enumerate my device as MSC but I want to write some data at some addresses of attached nand flashes(K9F2G08U0D-SIB0 in my case) and after verifying the read/write operation sucess, I would like to print the indication serially
Kindly help me in implementing it at code level