- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to use the GPIF and FIFO functions of CY7C68013A in this way:
1. Two channels of data transmission, CY7C68013 as a slave to receive data
2. The data format of each channel is: 1 clock pin, 8 data pins
3. The data rate is 9MHz
4. All data received are transferred to PC through USB
Can the above functions be achieved? Do you need any special attention if you can? Is there a example?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please note that such parallel functioning of modes is not supported.
Please refer to this KBA : https://community.cypress.com/t5/Knowledge-Base-Articles/Difference-between-FX2LP-Port-I-O-GPIF-and-...
Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please note that such parallel functioning of modes is not supported.
Please refer to this KBA : https://community.cypress.com/t5/Knowledge-Base-Articles/Difference-between-FX2LP-Port-I-O-GPIF-and-...
Regards,
Mallika