- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everybody,
i have a CY7C65213-32LTXI chip on my custom board.
It should work as a UART interface,
but when i connect to it it says it is in CY_TYPE_MFG mode and no UART SetFunction or even GetConfig will work.
- I tried to program it with "USB Serial Configuration Utility.exe" but it wont change the Device type...
- Do i need to program the Flash or what?
- even if, where can i get a binary to flash??
- or is it just the wrong driver???
tnx in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you create a tech support case at https://secure.cypress.com/myaccount/?id=25&createCase=techSupport with screenshot of "USB Serial Configuration Utility.exe" when device is connected?
-Haneesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, heres the screens from the Config tool. This is using a little Evalboard not the custom boar but i have the same Error with the API that i cannot get the uart config or even set.
many tnx in advance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have this exact same problem now. Has this been solved?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If the device is configured as UART under CDC mode, then the device type will be returned as CY_TYPE_MFG. Please set the protocol as Vendor mode in USB Serial Configuration Utility for CY_TYPE_UART.
Regards