When I tested USB Video Class by using FX3 to receive CMOS Camera signal, it is not working on host like below capture figure.

Anonymous · ‎Jul 09, 2014

All of signals(image sensor) are okey; PCLK, LINE_VALID, FRAME_VALID, 0~7 Data_bus.... But there is no data which receive from USB. So, I tested example of USBVideoClassBulk. It is good working. Why this situation is happened? Please give me some advise. Thank you.

Anonymous · ‎Aug 06, 2014

Hi

Which firmware are you using? Please share the firmware

Regards,

Vikas.

Learn how to optimise USB-C for your designs at 18 May's USB-C PD Webinar.
Click here to register.

When I tested USB Video Class by using FX3 to receive CMOS Camera signal, it is not working on host like below capture figure.

Re: When I tested USB Video Class by using FX3 to receive CMOS Camera signal, it is not working on host like below capture figure.

Learn how to optimise USB-C for your designs at 18 May's USB-C PD Webinar. Click here to register.

When I tested USB Video Class by using FX3 to receive CMOS Camera signal, it is not working on host like below capture figure.

Re: When I tested USB Video Class by using FX3 to receive CMOS Camera signal, it is not working on host like below capture figure.

Learn how to optimise USB-C for your designs at 18 May's USB-C PD Webinar.
Click here to register.