Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

USB hosts hubs transceivers Forum Discussions

TeMa_2997106
Level 6
Level 6
10 likes received 10 solutions authored 250 replies posted

My understanding is that when OVR is driven low, PWR automatically goes low. Is it correct?

My customer's board does not behave that. When OVR pin input low, PWR pin does not go high.

Where should I check on the board?

Thanks,
Tetsuo

0 Likes
1 Solution
MallikaK_22
Moderator
Moderator
Moderator
250 solutions authored 500 replies posted 250 replies posted

Hi Tetsuo,

OVR pin is active low. When overcurrent is detected, PWR (active low) should be disabled (HIGH).

If overcurrent is detected, amber led glows corresponding to that port.

Regards,

Mallika

View solution in original post

0 Likes
2 Replies
MallikaK_22
Moderator
Moderator
Moderator
250 solutions authored 500 replies posted 250 replies posted

Hi Tetsuo,

OVR pin is active low. When overcurrent is detected, PWR (active low) should be disabled (HIGH).

If overcurrent is detected, amber led glows corresponding to that port.

Regards,

Mallika

0 Likes
TeMa_2997106
Level 6
Level 6
10 likes received 10 solutions authored 250 replies posted

Mallika-san,

Thank you for your comment. I will check it.

Thanks,
Tetsuo

0 Likes