Mar 30, 2022
07:11 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 30, 2022
07:11 PM
When performing a compliance test at a certification body using a FW designed with FX3, do I need to make any special FW changes to put the FX3 project file into compliance test mode?
Solved! Go to Solution.
Labels
- Labels:
-
USB Hosts Hubs Transceivers
1 Solution
Mar 30, 2022
07:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 30, 2022
07:51 PM
Hello,
Please refer to the following KBA:
Best Regards,
Jayakrishna
Jayakrishna
2 Replies
Mar 30, 2022
07:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 30, 2022
07:24 PM
No firmware changes are required to enter compliance mode. The FX3 SDK handles it internally.
Best Regards
Mar 30, 2022
07:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 30, 2022
07:51 PM
Hello,
Please refer to the following KBA:
Best Regards,
Jayakrishna
Jayakrishna