Anonymous
Not applicable
Nov 26, 2014
05:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 26, 2014
05:50 PM
Hi,
I have a Cypress CX3 Kit attached to USB3.0 Port. I am trying to load an image to the firmware.
When I run Cypress USB-Serial Configuration Utility and click on the tab - Select Target. Select Device is grayed out, I assume it is not able to find the device. I installed drivers but still am not able to find the device listing in Device Manager.
Is there anything I am missing?
Thanks!
3 Replies