Anonymous
Not applicable
Dec 13, 2016
09:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 13, 2016
09:58 PM
Hi.
I will make new custom board using fx3 chip. and I want to UART port, but useable board area is too small to insert UART chip,
example codes that I received from Cypress Inc, have included USB UART(PID 0x0008) and USB bulk system(PID 0x00F0).
Should I use two or more PID in same a Fx3 chip ? If it is possible I want to know how to use that.
Regards.
Shin.
3 Replies