- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm looking for reference code to run MIPI interface of the AR0144 Demo 3 Head board with FX3.
Will appreciate any assistance.
Thanks,
Itay Cohen
Solved! Go to Solution.
- Labels:
-
USB Superspeed Peripherals
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Itay,
There is no particular reference design for FX3 with OnSemi AR0144.
Best Regards,
AliAsgar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Itay Cohen,
Please refer to the EZ-USB CX3: https://www.cypress.com/documentation/datasheets/cyusb306x-ez-usb-cx3-mipi-csi-2-superspeed-usb-brid...
Cypress’s EZ-USB CX3 is the next-generation bridge controller that can connect devices with Mobile Industry Processor Interface – Camera Serial Interface 2 (MIPI CSI-2) interface to any USB 3.0 Host.
Best Regards,
AliAsgar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is there any reference design for the CX3 to work with OnSemi AR0144 MIPI camera?
Thanks,
Itay
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Itay,
There is no reference design for CX3 to work with OnSemi AR0144.
The firmware examples in the FX3 SDK could be referred. Also the below KBA can be followed to create a firmware using the CX3 configuration utility. https://community.cypress.com/t5/Knowledge-Base-Articles/Steps-to-Setup-up-MIPI-CSI-Camera-Solution-...
Best Regards,
AliAsgar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is there a reference design for FX3 to work with OnSemi AR0144?
Thanks,
Itay
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Itay,
There is no particular reference design for FX3 with OnSemi AR0144.
Best Regards,
AliAsgar