Jun 29, 2021
01:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 29, 2021
01:11 AM
- Use CYUSB3014, if i provide 3.6V~4.2V to VBATT pin and make VBUS pin floating, can CYUSB3014 work normally with USB host ?
- in my special use, VBUS of usb host only provide 3.6V~4.2V, in this case, how can i do to make CYUSB3014 work normally with USB host?
Solved! Go to Solution.
Labels
- Labels:
-
USB Superspeed Peripherals
1 Solution
Jun 29, 2021
03:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 29, 2021
03:48 AM
Hello,
Please let us know the preferred boot mode so that we can understand the Application better to comment on the feasibility.
Also, please refer to the following thread which already mentions that FX3 requires a voltage greater than around 4.2V to be detected as Cypress USB Bootloader device:
Best Regards,
Jayakrishna
Jayakrishna
1 Reply
Jun 29, 2021
03:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 29, 2021
03:48 AM
Hello,
Please let us know the preferred boot mode so that we can understand the Application better to comment on the feasibility.
Also, please refer to the following thread which already mentions that FX3 requires a voltage greater than around 4.2V to be detected as Cypress USB Bootloader device:
Best Regards,
Jayakrishna
Jayakrishna