Anonymous
Not applicable
May 22, 2013
04:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 22, 2013
04:00 AM
hi everyone,
i have a device fx2LP and one LED is connected to PD0 of the IC. can i control the intensity of that LED through any firmware. can we use PWM for this. is it possible in FX2LP???
please help me
Regards
rohan
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
May 23, 2013
11:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 23, 2013
11:58 AM
Hi, FX2LP doesn't have PWM. You can use timers to control LED intensity. Please go through http://www.cypress.com/?docID=35114
3 Replies
Anonymous
Not applicable
May 23, 2013
11:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 23, 2013
11:58 AM
Hi, FX2LP doesn't have PWM. You can use timers to control LED intensity. Please go through http://www.cypress.com/?docID=35114
Anonymous
Not applicable
May 23, 2013
01:00 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 23, 2013
01:00 PM
THank u very Much sir. . .
i am going through the document for the same. n doing further development.
really thenks for all your help!!!
Regards
rohan
Anonymous
Not applicable
May 27, 2013
07:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 27, 2013
07:28 AM
Hi, You are welcome