- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I have a CY7C63803-SXC microcontroller
Can I connect it to miniprog4 to read, write and debug software?
What software should I use for this?
I am planning to use ISSP interface (d + d- pins)
If this is not possible, tell me which programmer is suitable
Solved! Go to Solution.
- Tags:
- cy7c63803
- programmer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @van_de ,
You can use CY8CKIT-002 PSoC™ MiniProg3 Program and Debug Kit to program CY7C63803-SXC using ISSP protocol. You can use PSoC Designer to develop firmware for this device. PSoC Designer comes with PSoC Programmer, which is the software used to program the device.
Best regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @van_de ,
You can use CY8CKIT-002 PSoC™ MiniProg3 Program and Debug Kit to program CY7C63803-SXC using ISSP protocol. You can use PSoC Designer to develop firmware for this device. PSoC Designer comes with PSoC Programmer, which is the software used to program the device.
Best regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the answer
I already ordered miniprog4 ...
Can't I use it to connect via ISSP?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately you will not be able to use MiniProg4 to program via ISSP.
Best regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Will it be possible to connect them through a different interface?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content