only download a time successfully and then occur to as below issue, and how to handle the issue?

Announcements

Live Webinar: USB-C adoption. Simple & Cost-efficient solutions | April 18th @9am or 5pm CEST. Register now !

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
JiMr_4783496
Level 1
Level 1

PD contract established.

Error: GET_SILICON_ID U_VDM failed

Retrying, ignore the above error message

PD contract established.

Error: GET_SILICON_ID U_VDM failed

Retrying, ignore the above error message

Error: GET_SILICON_ID U_VDM failed

Retrying, ignore the above error message

Flash update mode (4b4, 1) entered

Restarting the target device

Re-negotiating PD contract after switching target reset

Error: PD contract not established after RESET

Error: DLL call returned error while fetching info

Starting CCG firmware update over CC line

Could not establish PD contract.

Error: DLL call returned error while flashing

0 Likes
1 Solution

Hi,

There might be some problem in modified firmware that you have programmed. So PD contract is not getting established between the programmer and the CCG3PA.

If the hardware you are using is CYPD4532 EVK,

Please refer to Question: What should be done if the CCG3PA controller is not detected in the EZ-PD Configuration Utility? in the KBA Frequently Asked Questions on CY4532 CCG3PA Kit – KBA226613 

Best regards,

Pranava

Best regards,
Pranava

View solution in original post

0 Likes
3 Replies
Pranava_YN
Moderator
Moderator
Moderator
100 likes received 500 replies posted 250 solutions authored

Hi,

Please do clarify the following,

>> Are you trying to read/ Update configuration table from CY4532 EVK or some custom board?

>> Have you programmed any modified firmware to the board before getting this error?

Best regards,

Pranava

Best regards,
Pranava
0 Likes

have downloaded firmware before getting this error

0 Likes

Hi,

There might be some problem in modified firmware that you have programmed. So PD contract is not getting established between the programmer and the CCG3PA.

If the hardware you are using is CYPD4532 EVK,

Please refer to Question: What should be done if the CCG3PA controller is not detected in the EZ-PD Configuration Utility? in the KBA Frequently Asked Questions on CY4532 CCG3PA Kit – KBA226613 

Best regards,

Pranava

Best regards,
Pranava
0 Likes