Mar 29, 2021
06:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 29, 2021
06:51 AM
Hello,
I have connected a device on the I2C bus of the CYPD5225.
But this device has not the same power rail (it is 3V3 but not set at the same time) than the CYPD5225. I was wondering at witch supply do i need to connect the pull-up ?
Question: Do the SCB pins are 3V3 tolerant if the CYPD5225 is not powered ?
Thank you for help
Best regards,
TD83
Solved! Go to Solution.
Labels
- Tags:
- cypd5225
1 Solution
Mar 29, 2021
10:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 29, 2021
10:55 PM
CCG5 SCB pins is following VDDIO. To be safe, Kindly make sure the IO is powered later than VDDIO.
Best Regards,
Lisa
1 Reply
Mar 29, 2021
10:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 29, 2021
10:55 PM
CCG5 SCB pins is following VDDIO. To be safe, Kindly make sure the IO is powered later than VDDIO.
Best Regards,
Lisa