Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

USB EZ-PD™ Type-C Forum Discussions

JiMr_4783496
Level 1
Level 1

how to configure different CCG3PA device address if master control multi-devices over I2C communication,, and hope to provide the detailed documents and specified  sample code related to  the aspects issues, it is not very clear as below snap picture, according to the document, seem the device register address is not configurable  due to only three fixed model, thank you!

捕获.JPG

0 Likes
1 Solution
PranavaYN
Moderator
Moderator
Moderator
500 replies posted 250 solutions authored 50 likes received

Hi,

Host Processor Interface (HPI) is not supported in CCG3PA designs. Please refer to CCG3 projects from https://www.cypress.com/documentation/software-and-drivers/ez-pd-host-software-development-kit  for example implementation of HPI.

If you are looking for I2C(SCB) slave address setting in CCG3PA projects, please refer to I2C Component datasheet available in Component Catalog in PSoC Creator.

aaaa.jpg

Best regards,

Pranava

Best regards,
Pranava

View solution in original post

0 Likes
1 Reply
PranavaYN
Moderator
Moderator
Moderator
500 replies posted 250 solutions authored 50 likes received

Hi,

Host Processor Interface (HPI) is not supported in CCG3PA designs. Please refer to CCG3 projects from https://www.cypress.com/documentation/software-and-drivers/ez-pd-host-software-development-kit  for example implementation of HPI.

If you are looking for I2C(SCB) slave address setting in CCG3PA projects, please refer to I2C Component datasheet available in Component Catalog in PSoC Creator.

aaaa.jpg

Best regards,

Pranava

Best regards,
Pranava
0 Likes