- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Pure ,
Thank you for your feedback.
I will address this issue to software team. it will get updated in the next release.
Kindly refer Raw data in cy4500 for your current testing.
Best Regards,
Mohamed Rahmathulla
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Pure ,
Thank you for your feedback.
I will address this issue to software team. it will get updated in the next release.
Kindly refer Raw data in cy4500 for your current testing.
Best Regards,
Mohamed Rahmathulla
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much, but I have a small problem. CY4500 can capture EPR SRC CAP at present, but there seems to be some problems with PD3.1 translation. Can you correct them together. As shown below
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Pure ,
Current version of the protocol analyzer support till PD3.0. next version is planned to release on end of Q2.
we will get the updated PD protocol support in that release.
Thanks & Regards,
Mohamed Rahmathulla