Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

USB EZ-PD™ Type-C Forum Discussions

drewfustini
Level 3
Level 3
10 replies posted 10 sign-ins 5 replies posted

I have the CY4352 EZ-PD CCG3PA EVK and a MiniProg3.

I want to program the CCG3PA (CYPD3175-24LQXQ) over SWD with MiniProg3.

How should I configure the jumpers on the EVK?

The PDF did not seem to contain enough information.

Thank you.

Screenshot_20210129-132807.jpgScreenshot_20210129-132825.jpgScreenshot_20210129-132835.jpgScreenshot_20210129-132849.jpgScreenshot_20210129-132939.jpg

Screenshot from 2021-01-29 12-58-17.pngScreenshot from 2021-01-29 12-57-41.png

0 Likes
1 Solution
MallikaK_22
Moderator
Moderator
Moderator
250 solutions authored 500 replies posted 250 replies posted

Hi,

For SWD programming of CCG3PA the steps are as follows-

>> Remove any external supply to the kit.

>> Remove jumpers on J6 and J7 of the power board.

>> On jumper J6 of main board, short pins 2-3 (VDDD-VTARG).

>> Connect a MiniProg3 Programmer/Debugger (CY8CKIT-002) to the SWD header J1 on the main board and connect the MiniProg3 USB interface to a PC.

Please let me know if you face any difficulty in performing the above steps.

Regards,

Mallika

View solution in original post

1 Reply
MallikaK_22
Moderator
Moderator
Moderator
250 solutions authored 500 replies posted 250 replies posted

Hi,

For SWD programming of CCG3PA the steps are as follows-

>> Remove any external supply to the kit.

>> Remove jumpers on J6 and J7 of the power board.

>> On jumper J6 of main board, short pins 2-3 (VDDD-VTARG).

>> Connect a MiniProg3 Programmer/Debugger (CY8CKIT-002) to the SWD header J1 on the main board and connect the MiniProg3 USB interface to a PC.

Please let me know if you face any difficulty in performing the above steps.

Regards,

Mallika