- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have the CY4352 EZ-PD CCG3PA EVK and a MiniProg3.
I want to program the CCG3PA (CYPD3175-24LQXQ) over SWD with MiniProg3.
How should I configure the jumpers on the EVK?
The PDF did not seem to contain enough information.
Thank you.
Solved! Go to Solution.
- Labels:
-
USB EZ-PD Type-C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For SWD programming of CCG3PA the steps are as follows-
>> Remove any external supply to the kit.
>> Remove jumpers on J6 and J7 of the power board.
>> On jumper J6 of main board, short pins 2-3 (VDDD-VTARG).
>> Connect a MiniProg3 Programmer/Debugger (CY8CKIT-002) to the SWD header J1 on the main board and connect the MiniProg3 USB interface to a PC.
Please let me know if you face any difficulty in performing the above steps.
Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For SWD programming of CCG3PA the steps are as follows-
>> Remove any external supply to the kit.
>> Remove jumpers on J6 and J7 of the power board.
>> On jumper J6 of main board, short pins 2-3 (VDDD-VTARG).
>> Connect a MiniProg3 Programmer/Debugger (CY8CKIT-002) to the SWD header J1 on the main board and connect the MiniProg3 USB interface to a PC.
Please let me know if you face any difficulty in performing the above steps.
Regards,
Mallika